Adjustable Lever Leather Character Print Powerlifting Belt
Adjustable Lever Leather Character Print Powerlifting Belt
Belt size guide
| Size | Waist (cm) | Waist (in) |
|---|---|---|
| S | 65 – 80 | 25.5 – 31.5 |
| M | 72.5 – 90 | 28.5 – 35.5 |
| L | 80 – 100 | 31.5 – 39.5 |
| XL | 87.5 – 110 | 34.5 – 43.5 |
| 2XL | 95 – 120 | 37.5 – 47 |
| 3XL | 102.5 – 130 | 40.5 – 51 |
Measure around your waist at navel height, standing relaxed (don't suck in). If you fall between sizes, go by the measurement rather than your jeans size. The lever's multiple holes give you room to adjust on either side of your measurement.
Couldn't load pickup availability
A full-spec lever belt with character artwork printed across the outside. Under the print it's premium cowhide leather, 4 inches wide all the way round, with a double prong adjustable lever and a choice of 10mm or 13mm thickness. The print is for looks. The belt is for moving heavy weight.
Adjustable double prong lever
The lever closes with two prongs locking into two holes at once. That spreads the load across two points and keeps the belt flat and square against your stomach when you brace. Once the lever is pushed down it stays down until you open it. Flip it up and the belt comes straight off.
The lever position adjusts without tools. Release it, slide it to the hole you want, lock it back in place. Most people run a tighter hole for squats and back it off for deadlifts, where you need a bit more room to get set. It also means the belt keeps fitting as your bodyweight moves around, without sending it off to be altered or buying another one.
Leather and build
Premium cowhide, thick and rigid, with stitching around the edges. The width is 4 inches (10cm) front to back, so the back panel and the front are the same height and you get even support all the way round. New leather is stiff by design. Give it a few weeks of sessions and it'll shape to you.
Thickness
10mm is the better everyday belt for most lifters. Faster break-in, more comfortable across a long session, plenty of support for heavy squats and pulls. 13mm is the maximum thickness most powerlifting federations allow. Stiffer, heavier, longer break-in, and the firmest possible brace. Choose 13mm if squat support is your priority. Choose 10mm if you want one belt for everything.
Key features
- Adjustable lever, repositions in seconds without tools
- Double prong lever, secure two-point lock
- Quick release between sets
- Premium cowhide leather, stitched edges
- 4 inches (10cm) wide, uniform width
- Thickness: 10mm or 13mm
- Multiple holes to fine-tune the fit
- Full character print on the outside, red inside
Good for: squats, deadlifts, overhead press, heavy rows, and any compound lift where you brace hard.
Sizing: measure your waist at navel height, standing relaxed, and check the size chart. The holes give you adjustment either side of your measurement.
