Adjustable Lever Leather Powerlifting Belt - Purple
Adjustable Lever Leather Powerlifting Belt - Purple
Belt size guide
| Size | Waist (cm) | Waist (in) |
|---|---|---|
| S | 65 – 80 | 25.5 – 31.5 |
| M | 72.5 – 90 | 28.5 – 35.5 |
| L | 80 – 100 | 31.5 – 39.5 |
| XL | 87.5 – 110 | 34.5 – 43.5 |
| 2XL | 95 – 120 | 37.5 – 47 |
| 3XL | 102.5 – 130 | 40.5 – 51 |
Measure around your waist at navel height, standing relaxed (don't suck in). If you fall between sizes, go by the measurement rather than your jeans size. The lever's multiple holes give you room to adjust on either side of your measurement.
Couldn't load pickup availability
This is a full-size lever belt for squats, deadlifts and heavy pressing. Premium cowhide leather, 4 inches wide all the way around, a double prong lever that adjusts without tools, and your choice of 10mm or 13mm thickness. It's deep purple leather with a black lever.
The point of a lever belt is speed. You push the lever closed and you're braced. You flip it open and you're out. With a prong belt you're pulling the strap through a buckle every set, and by the end of a squat session that gets old. A lever belt closes and opens in about a second.
This lever goes a step further because the position is adjustable. Release it, slide it to a different hole, lock it down. No screwdriver, no taking the belt apart. That matters for two reasons. First, squats and deadlifts usually want different tightness: tighter for squats, a notch looser for deadlifts so you can get into your start position. Second, your waist doesn't stay the same all year, and with an adjustable lever you change the setting rather than the belt.
The lever has two prongs, not one. Both go into the belt at the same time, so the load is spread across two points and the belt sits flat against your stomach without twisting. It stays locked for as long as you want it locked.
The leather is premium cowhide, thick and stiff with stitched edges. It's 4 inches (10cm) wide from front to back, so there's no tapering at the sides and you get the same support all the way around. Expect it to feel rigid for the first couple of weeks. That's the leather doing its job. It softens a little and takes the shape of your torso with use.
On thickness: 10mm is the everyday option and the one we'd point most lifters to. It gives enough to be comfortable across a whole session and breaks in quicker. 13mm is stiffer and heavier, takes longer to break in, and is the thickest belt most federations allow. Heavy squatters who want the firmest brace possible tend to pick 13mm.
Key features
Adjustable lever, no tools needed to change position
Double prong lever for an even, secure lock
Opens and closes in a second
Premium cowhide leather, stitched edges
4 inches (10cm) wide, uniform width
Thickness: 10mm or 13mm
Multiple holes for fine-tuning the fit
Deep purple leather, black lever
Good for: squats, deadlifts, overhead press, barbell rows, and any heavy compound lift.
Sizing: take a tape around your waist at navel height, standing normally (don't suck in), and compare it to the size chart. When in doubt, trust the measurement over your pant size.
